KOUL TOOL

This handy composite device makes installing the socket over the cut end of the stainless hose a breeze. Simply open the clamshell, insert the socket, clamp the Koul Tool in a vise, or secure with Vise-Grip pliers.  Push the hose through the opening with a twisting motion, and the hard part of hose assembly is done. Three sizes in a box, and they fit all brands of A-N fittings, including Fragola, Aeroquip, Earl's, Russell, Goodridge, and XRP.

Important: The KOUL TOULS are NOT designed for use with teflon-style hoses.

NEW for 2008:

Updated pricing program!!

Most parts are at lower prices than before.

Instructions for Part #900510

(also known as KOUL TOOL p/n 468)

The small kit, Part #900510, contains the capsules to install -4, -6, -8 hose

into their respective sockets. To accommodate all the different manufacturer’s

fittings, spacers and sleeves are required to tighten up the some of the

sockets within the capsule.

For the tool to perform at its best, the socket needs to be a snug fit in the

funnel.  If the socket seems loose in the tool, use a spacer to tighten it up.

In the small kit, only the Russell -4 needs a sleeve.

Not for use with Teflon-style hose.

~~~~~~~~~~~~~~~~~~~~~~~~

Instructions for Part #900511

(also known as KOUL TOOL p/n 1016)

The large kit, Part #900511, contains the capsules to install -10, -12, -16 hose into

their respective sockets. To accommodate all the different manufacturer’s fittings,

spacers and sleeves are required to tighten up some of the sockets within the capsule.

For the tool to perform at its best, the socket needs to be a snug fit into the funnel.

All the -16’s except Russell’s require the sleeve and a rear spacer.

The instructions in the case specify the proper spacer number for the plumbing brand.

Most of the -10’s and 12’s will use a spacer.

Not for use with Teflon-style hose.